Tubing and Casing Pressure: Critical Variables for Optimizing ESP Performance
Why a 150–250 psi tubing-to-casing differential keeps free gas out of your pumps, and how too much tubing pressure quietly stresses the motor and VSD.
Why Surface Pressures Matter
Tubing and casing pressure are critical variables in optimizing ESP performance, and they become increasingly important as the well draws down. Low downhole pressure means more free gas breakout leading to gas interference (kryptonite for ESPs). This is especially true with continued cycling.
The Rule of Thumb: 150–250 psi Differential
A good rule of thumb is a 150–250 psi differential pressure between tubing and casing.
For example: if casing pressure is 100 psi, tubing should be 250–350 psi.
Since gas will want to travel in the direction of less pressure, this will ensure free gas can escape up casing and not be forced through the pumps. Some scenarios may call for more tubing pressure, for which smaller step changes are always the best approach.
The Flip Side: Too Much Tubing Pressure
The flip side to this coin is too much tubing pressure can also be detrimental:
TDH = Vertical Lift + Friction Loss + Surface Pressure
Higher TDH will require more horsepower, adding additional stress to the motor and VSD. As a result, higher operating temperatures and overload shutdowns are possible. Ensure the amperage limitations of the motor and VSD are known and monitored.
Other Considerations
- ✅ Backpressure regulators have an advantage over standard chokes on ESPs, because they adjust to multi-phase flow conditions allowing more consistent back pressure.
- ✅ Real-time monitoring of pressures with SCADA is crucial.
- ✅ Advanced software with nodal analysis solutions helps quantify the impact of surface pressure changes on the downhole system.