Skip to main content
Jul 12, 2026•Reliability Engineering

Lead Washers: The Small Component That Decides ESP Run Life

Up to 30 lead washers seal wellbore fluids out of the seal section and motor — without verified compression during assembly, premature failure is inevitable.

J
James BritvarEngineer

Are You Inspecting Lead Washers?

Are you inspecting the lead washers on seal assemblies and motors during new ESP installations? If not, these systems are at risk for premature failure. ESPs might run for months, days, or fail right away if the washers aren't compressed properly.

Why Lead Washers Matter

A typical ESP system includes up to 30 lead washers between the tandem protector and motors. They're essential for keeping wellbore fluids out of the seal section and motor. Lead works well because it's malleable — when compressed correctly, it forms a tight seal against mating surfaces and holds up well in downhole conditions.

No Standard Procedure for Compression

At Dwiggins Consulting LLC, our reliability team has seen plenty of failures tied to lead washer problems. The problem is there's no standard procedure for compression. Some vendors use torque wrenches, others torque plus hand tighten, and some just hand tighten. No matter the approach, without verification, the system is vulnerable. It all comes down to the technician, and that leaves room for error. Consistency is tough and requires strong quality assurance during assembly.

The result: if compression isn't verified, failure is inevitable. When washers fail, wellbore fluid gets in, leading to faster wear in the thrust chamber or electrical shorts in the motor.

What's the Fix?

Ensure industry practices are being used during pre-checks and assembly:

  • ✅ Verify all washers are properly compressed.
  • ✅ Have a second person witness pre-checks and assembly.
  • ✅ Use visual guides showing correct compression.
  • ✅ Conduct DIFA to check washer performance.

Setting the Standard

Vance Fielder, Graham Breakey, and Kristen Munguia have been at the forefront of driving improvement in the field and setting the standard for reliability of lead washers by first identifying when there is an issue through DIFA and install audits, and then by collaborating with manufacturers to improve their QA procedures in the field.